View Posts
MatterHackers Forum
This forum has been set to read-only for archival purposes. Please visit our Community Forum to ask and participate in active discussions.
Remove Post
First Print Layer using Robo3d + keeps breaking along the seam
by Joshua Taylor

My first print layer doesn't seem to fully adhere to the sides when printing.

I currently have the first bottom layer set to .4, which is the highest it will let me set it to as the nozzle flow is .4

I feel if I was able to set this slightly past 4, my issue would go away.

Any suggestions?

Joshua Taylor - October 31st, 2015 at 8:24a.m.

Increasing the layer height beyond the limit is probably not the best route to take. What kind of bed surface are you using and what material are you printing with?

tanderson - November 3rd, 2015 at 1:35p.m.