View Posts
MatterHackers Forum
This forum has been set to read-only for archival purposes. Please visit our Community Forum to ask and participate in active discussions.
Remove Post
z offset
by
Guest
how do i mess around with this? looks like after auto leveling the filament just falls onto the bed
Guest
-
December 22nd, 2015 at 9:14a.m.
Z Offset can be adjusted under Settings & Controls -> Settings -> Printer -> Print Area.
ryan.lutz
-
December 22nd, 2015 at 9:47a.m.
any recomendations for proceeding? my setting currently is at 0 but the nozzle is rather far off the bed
Guest
-
December 23rd, 2015 at 11:48a.m.
You can adjust the Z offset in the setting noted by Ryan.
If you are far from the bed, you will want to use a negative z number.
Taylor
-
December 29th, 2015 at 12:00p.m.