MatterHackers CleanTip High Flow Heater Block
This MatterHackers CleanTip™ High Flow aluminum Heater Block is coated with ultra-low friction Tungsten Disulfide, resulting in less mess and easier cleaning! Manufactured in the USA.
Note: This heater block is a direct replacement for use in extended melt zone hot ends, such as the E3D Volcano.
|Order Now:||Ships calculating...|
If you've had your 3D printer for more than a few weeks, you know it doesn't take long for your heater block to go from this:
Our new CleanTip™ Nozzles and Heater Blocks are the solution. Coated with ultra-low friction Tungsten Disulfide (WS2), no filament sticks to our stainless steel nozzles and aluminum heater blocks.
Tungsten Disulfide is a really cool material. It has even less friction than PTFE and is heat resistant up to 650°C.
These photos show an uncoated heater block (left) and a coated block (right) after approximately 1 month of printing:
When your hot end is up to temperature, it wipes clean with virtually anything. No more baked on filament mess or difficult nozzle swaps due to crusty old filament.
Note: The photos above are of the standard sized CleanTip™ Heater Block. The High Flow Heater Block is a direct replacement for extended melt zone hot ends, such as the E3D Volcano, and must be used with Extra Long CleanTip™ nozzles.