This MatterHackers CleanTip™ HeatBreak is coated with ultra-low friction Tungsten Disulfide, resulting in less mess and easier cleaning! Manufactured in the USA.
Note: This heat break is a direct replacement for use in E3D v6 1.75mm hot ends
|Order Now:||Ships calculating... Free U.S. Shipping|
Are you tired of your hot end parts getting dirty and covered in filament?
Our new CleanTip™ replacement parts are the solution. Coated with ultra-low friction Tungsten Disulfide (WS2), no filament will be sticking to your HeatBreak and other hot end parts.
Tungsten Disulfide is a really cool material. It has even less friction than PTFE and is heat resistant up to 650°C.
When your hot end is up to temperature, it wipes clean with virtually anything. No more baked on filament mess or difficult nozzle swaps due to crusty old filament.
These photos show normal, uncoated hot end components compared to our CleanTip™ Tungsten Disulfide coated parts after approximately 1 month of printing (no cleaning or wiping done):
Uncoated vs coated heater blocks
Uncoated vs coated nozzles
Note: The CleanTip™ HeatBreak is a direct replacement for use in E3D v6 1.75mm hot ends
Put simply, MatterHackers is the smart place to shop for all things 3D printing and digital manufacturing. The MatterHackers pros are here to partner with you through every step of your journey turning idea into reality and here are just a few of the perks you’ll receive as a customer:
Have a question about this MatterHackers CleanTip Heat Break - 1.75mm? Looking for a recommendation? No problem. Feel free to contact us.