ColorFabb ColorFabb Natural varioShore TPU Filament - 2.85mm (2.0kg)

This revolutionary new material from Colorfabb allows users to vary the density of printed parts by adjusting temperature and material throughput - At temperatures between 200°C and 250°C the material will start to expand to roughly 1.4 - 1.6 times its original volume. When printed at low flow rates (60-70%) the active foaming properties will cause parts to expand, resulting in very soft printed parts. At temperatures between 190°C and 200°C the material can be printed without foaming, which results in harder prints when compared to those that utilized Varioshore's active foaming properties.

The base TPU is 92A, which will work with most standard extruder set-ups.

loading...
Product No. loading...

Printing soft parts, such as bike handlebars or shoe soles, couldn't be easier with varioShore TPU!

VARIOSHORE IS FLEXIBLE TO THE TOUCH AND FLEXIBLE IN ITS APPLICATION:

Although not quite as lightweight as LW-PLA, ColorFabb varioShore TPU provides users with noticeable weight and density reduction where it matters and the flexibility to use the material in a wide range of other applications. This material is well suited for producing soft sporting goods such as bicycle handlebars or for applications in footwear such as shoe insoles. 

The base TPU is 92A, which will work with most standard extruder set-ups for Bowden and direct drive systems.

By adjusting material flow rates, ColorFabb varioShore enables users to significantly reduces the weight and density of printed parts.

HOW TO SUCCEED WHEN PRINTING WITH VARIOSHORE TPU

The following settings are recommended for successfully printing with this material:

Print Temperature:

  • 190°-250°C

Print Speed:

  • 20-30mm/s

Print Bed Temperature:

  • 20°-40°C

Cooling Fan:

  • Users are advised to use the least amount of cooling possible when maximum foaming is desired. For better overhang performance use 50-100% speed when cooling. Additionally, it is advised to make sure the distance between the nozzle and print surface is not too small, especially if the material is foaming while printing - pressure will need to be released from the hot end to prevent clogging and material feeding issues.

This material is not limited to one shore hardness - with the right print settings you can have multiple shore hardnesses in one print!

TECHNICAL SPECIFICATIONS:

  • Spool Size: 2.0kg
  • Diameter tolerance: ± 0.1 mm
  • Density: 1.2-1.3g/cm-3

Technical Data Sheet

Material Safety Data Sheet

Back to top