FYSETC SB CAN Tool Board
The SB CAN Tool Board is a printhead control board with an STM32F072 processor and Klipper firmware. It's compatible with the Voron 2.4 3D printer and includes a variety of hardware for a convenient out-of-the-box experience.
- STM32F072 Processor
- Klipper Firmware
- Includes additional hardware
| List Price: | $34.00 |
|---|---|
| Price: | $34.00 |
| Price: | $... |
| Order Now: | Ships calculating... |
SB CAN Tool Board
The SB CAN Tool Board is a printhead control board featuring an STM32F072 processor and Klipper firmware to allow the onboarding of TMC2209 stepper motor drivers, an AXL345 acceleration sensor, and other essential interfaces.
Key Features of the SB CAN Tool Board:
- Uses a STM32F072 Processor
- Runs Klipper Firmware
- Compatible with the Voron 2.4
- Includes 2.5m 4-core cable
WHAT'S INCLUDED WITH THE SB CAN TOOL BOARD?
- 2x 0.5A MAX PWM Interface
- (default VIN power supply, 5V optional)
- 1x Signal Input Interface
- (VIN power supply, with level conversion)
- 2x Signal Input and Output Interface
- (5V power supply, with pull-up resistor)
- 1X 5V Single Wire RGB Interface (1A MAX)
- 1x 4A MAX PWM Output
- 1x ADC Interface
- 1x Micro USB
- 1 x 2.5m 4-Core Cable
- 2 x 16AWG
- 2 x 24AWG
- MX3.0 2X2 Interface
- Set of Terminal Housing Tabs
- Set of Wire Crimping Tabs
*Note that Technical Assistance is limited by our support team due to the nature of this product. Please refer to the guide linked above or connect with the Voron Discord, Voron Forum, and/or the Voron Design Subreddit for further assistance in installing this product.
