MatterHackers CleanTip HeatSink - 1.75mm Universal
This MatterHackers CleanTip™ aluminum HeatSink is coated with ultra-low friction Tungsten Disulfide, resulting in less mess and easier cleaning!
This heat sink is a direct replacement for use in E3D v6 1.75mm hot ends
|Order Now:||Ships calculating...|
Are you tired of your hot end parts getting dirty and covered in filament?
Our new CleanTip™ replacement parts are the solution. Coated with ultra-low friction Tungsten Disulfide (WS2), no filament will be sticking to your HeatSink and other hot end parts.
Tungsten Disulfide is a really cool material. It has even less friction than PTFE and is heat resistant up to 650°C.
When your hot end is up to temperature, it wipes clean with virtually anything. No more baked on filament mess or difficult nozzle swaps due to crusty old filament.
These photos show normal, uncoated hot end components compared to our CleanTip Tungsten Disulfide coated parts after approximately 1 month of printing (no cleaning or wiping done):
Uncoated vs. Coated Heat Blocks
Start enjoying all the benefits of the CleanTip coating on your heat sink today because the CleanTip HeatSink is a direct replacement for the standard E3D heat sink and ready for use in any E3D v6 1.75mm hot end. Get the most out of our CleanTip technology by combining with other CleanTip hotend components!
Check out the full line of CleanTip Products here:
- CleanTip Heater Block
- CleanTip High Flow Heater Block
- CleanTip HeatSink
- CleanTip HeatBreak
- CleanTip Nozzles