MakerGear MakerGear V4 Hot End - Brass - 0.35mm

The MakerGear M3 family of 3D printers are massively reliable machines that hold calibration and enable dependable, repeatable results. The stock machines comes assembled with 0.35 brass nozzles, perfect for PLA, ABS, PETG, and many more 3D printer filaments. This hotend is a direct replacement for the standard hotend, perfect to have on hand as a spare or replacement part. This is a fully assembled hotend with the 0.35mm nozzle pre-installed.

List Price: $85.00
Product No. M-J8L-QY65

Keep a spare hotend on hand

The MakerGear M2, M3, or M3 Independent Dual Extruder 3D printer is built to take on the toughest job's you could throw at it. Capable of creating strong and beautiful parts, the stock machine includes a 0.35mm nozzle perfect for most general purpose 3D printing. This hotend is a direct replacement for the stock unit and is useful to have on hand as a replacement/spare part. This package is a pre-assembled hotend, which can easily be swapped out to replace the stock unit.

The fully assembled M3 brass hotend

Easy to install for a quick upgrade

This package includes the nozzle, heater block, heat break, heater cartridge, and thermistor, pre-assembled and ready for installation. Changing out the hotend is a simple process, here is the breakdown:

  1. Unload any filament from your M3
    1. Let the hotend cool before continuing
  2. Disconnect the white heater cartridge wire from the 'H' port on the toolhead
  3. Disconnect the black thermistor wire from the "TH' port on the toolhead
  4. Loosen the M2.5 set screw on the side of the toolhead
  5. The hotend is now disconnected from the toolhead. Double check that the hotend is cool enough to handle with your bear hands! Gently pull down on hotend assembly, twisting a little if necessary and the entire unit will slide out.
  6. Slide the new hotend in place
  7. Tighten the M2.5 set screw
  8. Reconnect the cables for the thermistor and heater cartridge
  9. Check everything is tight
  10. Reload filament

A view of the M3 toolhead, the hotend set screw mentioned in steps 4 and 7 is visible in the lower right.

A closeup of the 0.35mm brass nozzle installed on this hotend

Notify me when this item becomes available

Available Financing

Back to top