This MatterHackers CleanTip™ Heater Block is coated with ultra-low friction Tungsten Disulfide, resulting in less mess and easier cleaning! Manufactured in the USA.
Note: The heater block design has been updated to match the v6 heater block for sensor cartridges.
|Order Now:||Ships calculating... Free U.S. Shipping|
If you've had your 3D printer for more than a few weeks, you know it doesn't take long for your heater block to go from this:
Our new CleanTip™ Nozzles and Heater Blocks are the solution. Coated with ultra-low friction Tungsten Disulfide (WS2), no filament sticks to our stainless steel nozzles and aluminum heater blocks.
Tungsten Disulfide is a really cool material. It has even less friction than PTFE and is heat resistant up to 650°C.
These photos show an uncoated heater block (left) and a coated block (right) after approximately 1 month of printing:
When your hot end is up to temperature, it wipes clean with virtually anything. No more baked on filament mess or difficult nozzle swaps due to crusty old filament.
Note: This heater block is a direct replacement for E3D v6 hot ends, and if you don't have any of the hardware for assembly, you will also need the E3D Fixings Kit so you can install this Heater Block into your hotend assembly.
Put simply, MatterHackers is the smart place to shop for all things 3D printing and digital manufacturing. The MatterHackers pros are here to partner with you through every step of your journey turning idea into reality and here are just a few of the perks you’ll receive as a customer:
Have a question about this MatterHackers CleanTip Heater Block? Looking for a recommendation? No problem. Feel free to contact us.