LDO Systems LDO Voron 2.4 R2 300 3D Printer Kit

With a big print volume of 300mm x 300mm x 300mm, the Voron 2.4 has one of the largest print volumes available at MatterHackers. Reduce the number of models you need to split into separate pieces to fit within your build plate! Or if you have one small design and need hundreds of them, 3D print huge batches on the super-flat milled aluminum build plate.

• Print Volume: 300mm x 300mm x 300mm (11.8" x 11.8" x 11.8")
  • Click here for the 350 print volume.
• Prototype or create large end-use parts in-house
• Print huge batches at once
• Beneficial for a wide variety of industries

The most common 3D printers use bearings and linear rods, an affordable and simple design that allows for a little play in the system, as these machines aren't intended to move fast. Once you approach speeds near 100mm/s, that play burdens the possible results you could hope to achieve. Linear rails are significantly more constrained and with the properly chosen pre-load prevent the various carriages from vibrating and wobbling throughout motion.

• 7 Stainless Steel Linear Rails
  • Four guide the Z axis
  • Two guide the Y axis
  • One guides the X axis

In order to 3D print at high speeds, you need a 3D printer that's as rigid as possible to limit any resonant frequencies. Many common 3D printers have a bed that constantly moves along Y or regularly moves along Z, but the Voron 2.4 has a bed that doesn't move at all; it is rigidly mounted to the frame. By utilizing a "Flying Gantry" style motion system, the 3D print is able to be locked down to the build plate throughout the 3D print without any fears of a wobbling cantilevered bed or the inertial mass that would need to be considered.

• Milled MIC6 Aluminum build plate is 6mm thick to ensure plenty of thermal mass to soak heat and remain flat throughout heatup cycles.
• Magnetic sticker can remained magnetized at temperatures necessary for ABS 3D printing temperatures
• Double sided, flexible spring-steel build plate allows you to easily switch between smooth or textured PEI to improve part adhesion and flex and twist the build plate to remove finished 3D prints.

By carefully using the power of mains voltage, the silicone heater mat is able to reach temperatures as high as 110°C within a couple minutes. By connecting the included thermal fuse, risk of thermal runaway is mitigated, as an overheating bed will cause the fuse to burst and disconnect power to the bed heater.

• 120VAC 750W silicone bed heater
• Adheres to the underside of the MIC6 aluminum build plate.
• Thermal fuse bursts at 125°C for thermal runaway protection
• Grounding wire protects the user from faulty wiring.

The entirety of the Voron 2.4's construction remains within the space of the frame; not a single part leaves the volume created by the frame. This makes enclosing the 3D printer simple and easy as you can easily mount panels using the T-slot frame. Included with this kit are all the clear acrylic panels you need to enclose the build volume and have a magnetically latching set of front doors. Before you 3D print the panel clips and begin enclosing the printer, make sure all the components are able to withstand the higher temperatures that will be generated; enclosing the build volume is for ABS and aluminum parts kits only, but panels are included with all kits.

• Fully enclosable by design
• Keeps drafts out and hot air around temperature sensitive parts
• Contains any possible fumes that can be vented through the included exhaust fan assembly.